ATTO Technology UL3D Specifikace stáhnout pdf (Strana 73)

4-25

Removing and Installing the Fan

Installing the Fan

To install the fan:

1. Loosen the two wing nuts and make sure the movable extension is

as far back as it can go as shown in Figure 4-12.

2. Place the two fan tabs, located at the rear of the fan, into the lowest

holes of the rear airflow grate. There is an illustration on the fan

that shows the actual insertion points for the tabs (see Figure 4-12).

Figure 4-12 Fan Tab Location

3. Gently press the fan portion onto the board set.

4. While holding the fan portion in place so the tabs don’t move,

extend the movable extension toward the front of the system

making sure the middle piece of the extension goes under the

plastic while the two outer pieces go over the top (see Figure 4-13).

Insertion

illustration

Tab s

Rear airflow

grate

Movable

extension

Wing nuts

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 129 130

Žádné komentáře

ATTO Technology UL3D Specifikace Strana 73